Why high Voltages come in multiple of 11, like 11 KV, 33KV,
66 KV, 132 KV etc.
- 11 Answers
- 20910 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanju
yes i agree with the 1st answer. its almost the perfect answer
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
how to check ac servo motor
i have done diploma and btech in EE and live in Chandigarh so kindly help me how can i make my competency certificate in my area.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
describe the phenomena of vacuum interruption in C.B
what is POTT and PUTT explain?
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
Can i use the B-curve MCB instead of C-curve MCB
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
what is acceptance test in electrical engineering.
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
how much flux density of CRNO core
testing of Vector Group – YNaoD II
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
what is plunger and what's the use of it in motor alignment?
