Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pritam halder
When an extra high voltage transmitted in a
transmission line, due to magnetic effect on the core of
the conductor all most all electronics pass on the surface
of the conductor. So the air outside the conductor surface
becames conducive and looks bluish and due to dielectric
breakdown of air a hissing noise comes from surrounding,
Called as corona !
Due to corona OZONE formation on the outside surface of the
conductor. The effect of this to the power system is called
as corona effect.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
How to test Alternator stability test for REF relay
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
Is there any standard guidelines/Criteria to design NGR/NGT.?
What is an order of a system.
What about electrical Units. discrive in detail
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What is meant by cold loop test in instrument
