Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sekar
The system which has contains controller and giving output
to wellhead pumping motor accordingly crude oils pressure
or viscosity thats called well head protection system,
while well head pumb runnng time this system will monitor
crude oils discharge pressure,motor vibration,bearing
temperature these all
normally every well head contains one controller panel
itself this controller will monitor all above mentioned
this is called well head protection system
Actually there are different type of wells in oil field:
skid pumb(lufkin ie.. donkey pumb)
screw pumb
these pumbs are decided by vendors which is suitable for
purticular location
example: if low viscosity crude oil or where oil level is
very high there can choose screw pumb, same way high
viscosity crude location there may skid pumb
Thanks
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
How to measure the dust in chimney(spm)?
how to calculate range of level transmitter?
what is span value and zero ? and how set ?
How to check vortex flow meter is in good condition while we do not having calibration setup?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
Questions on flow meters,few questions on HART protocol,
use of split range ? where it is used ? in which control loop it is used ?
What is cut off relay? And why use in PLC and DCS?
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
Which products are available in the Mass Systemswitch and System Manager AC range?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
what is function of SCADA , and how is it work, explain with difination
control panel design guidelines
Why plc require in analog input 4-20amp & 0-10 volt?
What is loop1 and loop2 in MTS LT?
