Answer Posted / vinodkumar
oil natural air natural
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
how we sesign the transformer give some specifion regarding design of transformers
What is the actual calculation for transformer short circuit test?.
Purpose of providing neutral isolation panel for parallel operation of diesel generator
why we used dc supply for field in dg set
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
Draw the line diagram of diffretial relay connected to transformer?
derive DC RMS value for half wave rectifier?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
what is gridrotor resistance starter
Define non-touching loop.
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
Why does the radius of armature is less than the radius of pole shoe?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
