Interested to Buy Any Domain ? << Click Here >> for more details...
difference between limit state method and working stress in
terms of load
- 6 Answers
- 16220 Views
- CCCL, I also Faced
- E-Mail Answers
Answer Posted / karthick.k
In case of design procedure , the facted load can be taken
for limit state mtd, by working stress method axial load
can be taken and strength of material is low, by limit
state method strength of material is high.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Suppose you planning to paint newly fabricated workshop building made of structural steel of 10 tons total mass. How many litters paint primer for 1 coat and 2 coat of top coat?
what is the minimum cement content for M20 & M25 as per is code -456(2000).
What is hybrid foundation?
Explain what are the phases inspections are done by local authority while construction?
20mm thick sand face plaster on walls consisting of 12 mm the backing coat of c.m.(1:3)and 8mm thick finished coat of c.m.(1:1)including scaffolding, watering, finishing etc complete please calculator with methyl et et r u
What is thumb rule in quantity and cost estimation of a residential building?
Which is the best book for building construction?
How can you distinguish between sorption, absorption and adsorption?
16 questions out of 55 were from the book GUPTA N GUPTA OBJECTIVE of civil engineering. Total ques were 4 ques from hydraullics, 7 from BMC, 4 FROM SOM, 4 from soil mechanics, 6 from transportation, 5 from engineering drawing.
Please Clear My doubt . We Can Design the size of the beam by manually by the Length of the beam...What is the technique adopted
whaat is blister in box girder bridge and what is its function..
how much cement and sand required for 1cum rr masonry
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
