Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / miracle
jhjkhjkh
The no of US GALLONS PER MINUTE OF WATER GOING THROUGH THE
FULLY OPENED CONTROL VALVE WITH THE LOSS OF ONE psi thats
called CV(CAPACITY OF VALVE)
FORMULAE:
Cv=Q*SQRT OF DP/SG
WHEN
DP= ACROSS THE VALVE
SG= SPECIFIC GRAVITY
Q=VOLUME FLOW MAX
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How INtools is useful for routine Instrument maintenance?
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
what is loop1 and loop2 in MTS LT?
what are the use of belew gear in general ??
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What is Erosion in a control valve?
please send me the inteview questions in IOCL
what is a half wave, full wave, and bridge rectifer.
If P will increase then what will happen with PID?
what is the importance of CV in the control valves? how it is calculated?
what is performance test.need defination
what are the steps I have to deal with?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
