Interested to Buy Any Domain ? << Click Here >> for more details...
what is the static device rather than xmer which work on
same principle as xmer?
- 18 Answers
- 25975 Views
- NTPC, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / rahul joshi
inductin motor
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
List out the the types of Mounting Light fixture?
How much ph is maintained of water resistance starter for slipring induction motor ?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
WHAT IS ELECTRICAL MAINTAINTENCE ?
Explain The Application Of Storage Batteries?
Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??
How I calculate the ELCB for circuit breakers?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
what is the question paper model for section engineer in RRB
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
