Interested to Buy Any Domain ? << Click Here >> for more details...
what is plc? Basic function of plc? application of plc in
industry? What is lader diagram ? What is the main advantage
to use plc in industry?
- 15 Answers
- 106133 Views
- Schlumberger, I also Faced
- E-Mail Answers
Answer Posted / nilesh yadav
A PLC has many "input" terminals, through which it
interprets "high" and "low" logical states from sensors and
switches. It also has many output terminals, through which
it outputs "high" and "low" signals to power lights,
solenoids, contactors, small motors, and other devices
lending themselves to on/off control. PLCs are industrial
computers, and as such their input and output signals are
typically 120 volts AC, just like the electromechanical
control relays they were designed to replace. Although some
PLCs have the ability to input and output low-level DC
voltage signals of the magnitude used in logic gate
circuits, this is the exception and not the rule.
| Is This Answer Correct ? | 36 Yes | 17 No |
Post New Answer View All Answers
Full form of KKS when use DCS.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
How to work temperature gauge?
why we are not using the turbine flow meter in the steam service?
What are different types of orifice plates?
What is loop1 and loop2 in MTS LT?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
How to Calibrate Interface Level Troll in field
What is frequency factor in massflow meter? When using frequency output?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Make Heater Process Logic.
Please tell me details about Sox,Nox,SWAS analyser????
What is profibus?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
