Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between MCCB & ACB & VCB
- 4 Answers
- 9414 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / santhosh
mcb is low capcity ,acb is high,vcb control sprk high
volteg
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
Why the efficiency of generator is more than motor in swinburne's test
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
how to compute kvar in substation feeder to improve power factor and sending voltage
how we arrange the hv side with delta connection in case 33/11kv of transformer.
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
Can anyone explain me about the capacitor calculation
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
where solid grounding and where grounding through ngr done and why?
How does zener phenomenon differ from avalanche breakdown?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
Why earthing is necessary for any equipment?
