Interested to Buy Any Domain ? << Click Here >> for more details...
if my 6 kva UPS gives 20 min. backup at 100 % load, then at
25% load what is the backup time?
- 17 Answers
- 19304 Views
- I also Faced
- E-Mail Answers
Answer Posted / gopalakrishnan
50 minutes
for example let us take four fans at 100% load for 20 minutes.
100% load means 4 fans = 20 minutes
75% load means 3 fans = 30 minutes
50% load means 2 fans = 40 minutes
25% load means 1 fan = 50 minutes
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How many ohms are required for proper earthing?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Why MUX JB's are using only Temperature Element in Fundation field bus?
How to Calibrate Coriolis Flow transmitter in field
what is the reason while warning lamp is on while the engine is cranking?
how do we commission inergen system?
how to calibrate corollaries (Mass flow meter)?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
What is the minimum rating availalbe for weld neck orifice in market?
What is the procedure of calibration of Load cell?
components of control circuit belongs to control valve
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
