how can we measure the level measurement with the help of
pressure gauge?
Answer Posted / sathya
well....suppose if you want to measure level of a
tank....connect your PG at the the bottom of the tank.for
eg. if your PG shows 5ksc pressure. then 5ksc is approx.
equal to 50000 mm WC..which is approx. 50 mtr.so level in
the tank would approx. 50 mtr.
Is This Answer Correct ? | 19 Yes | 7 No |
Post New Answer View All Answers
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
If we increase only P what will be controller action ?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
What is the difference between ff transmitter and non ff transmitter
Question on maha cement
for oil & gas industries which zone is normally preferred? why? give its example?
What is the Working principle of Dozing valve?
Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
How does your previous experience relate to the job you are applying for ?
what is the vital subject for scoring bhel exam&what is the question pattern
How to check vortex flow meter is in good condition while we do not having calibration setup?
Explain bernoulli’s theorem. State its application.
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Why thermo wells are used? What materials are used in thermo wells?