Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / c.dass
match voltage , frequency and phase angle and than
synchronise one by one.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is meant by positive and negative feedback?
what are carbondioxide and dcp used in fire extinguishers
What is Tachometer used to measure?
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
how to select the isolation tranformer for siemens 802dsl cnotroller
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
how does an encoder work???
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
describe the fully control circuit diagram of ac drives
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
1hp= how much rpm
