Interested to Buy Any Domain ? << Click Here >> for more details...
why we step down the voltage from 440 to 220 in machines
- 4 Answers
- 6985 Views
- I also Faced
- E-Mail Answers
Answer Posted / ginijayaram
please connect one end of the same watts lamp in each phase
and other end of the lamps connect common point . then take
that point is zero potential. and take one phase in one lamp
side.that two points give to 220 vols in machine
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is lifting power for 1 wb/m2 and 1 A magnet?
why dimmerstate always connected in star connection? what will happen if it connected in delta?
What is transister define the transister ammiter ,base, colector.
what is 30-phase of transformer
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
whate is the meaning of balance/unbalance,in stabilizers type
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
Do u know any one? how to find out in motor rated amps? formula?
bsec exam syllabus (mis)
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
what is die electric strnth of transformer ?
what is the string efficiency
