Answer Posted / guest
yes
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
A cotter joint is generally used to transmit
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
Is it possible to connect a safety device in to parallel?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
Define pole pitch?
plz tell me,ht and lt panel terminals in substations explain beiefly
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
Why back emf used for a dc motor? Highlight its significance.
Explain about c.t?
Can a generator runs after getting 1st stator earth fault.
What are dependent sources?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.