Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
In case of HT and EHT,to get rid of high voltage.In case of
LT CT ,to reduce the size of the leads.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
how to calculate fault level?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
What is marx circuit?
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
How to calculate the Harmonics losses in terms of cost/unit.
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
how to calculate micom relay earth falt time and current sertting
one split ac how can told of this ac which Tr tell me us
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
