Interested to Buy Any Domain ? << Click Here >> for more details...
what is the load amp of a 2 hp single phase motor?
- 6 Answers
- 10305 Views
- I also Faced
- E-Mail Answers
Answer Posted / binod prasad
Convert hp into watts.
746w=1hp
Power=V*I*pf.
2*746=230*I*0.8.
I=(2*746)/(230*0.8).
I=8.10A
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
why does the magnetic balance tests at transformer?
whats the application of voltage regulation? and whats the voltage regulation's device?
As we use capacitor bank in 3ph ckt to improve PF, can we use capacitor in single ph domestric use, in house we have Fan,Mixer,electric cooker,iron,tube choke they also lag the system,because it is inductive load. if it is possible to improve PF of single ph system-- if yes- type of capacitor to be used,connection diagram, working in detail. if no-- list it.
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
write down the formula of cable size in RM if current is 50Amp.
Define de-sensitivity?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
why we need to us lenz's law for synchornous motor
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Q: How to calculate Transformer losses , tell us by Formula.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
