Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nirmala
15 W
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
what is dry and wet frequency withstand voltage? why & where it is used??
importance of reactive power management
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
What is the difference between a verilog task and a verilog function?
For a spring controlled governer the relation F = ar+b (F is the controlling force, r is the radius of rotation a and b are constants), indicates that the governer is
How to convert 2 phase to 3 phase electricpower in induction moter?
Name the test signals used in control system
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
State and define ohm’s law?
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
which type of cabel
Why is negative feedback invariably preferred in closed loop system?
