Answer Posted / karuna
a) two conductors
b) two coil sides
c) two turns
d) four turns
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Can a generator runs after getting 1st stator earth fault.
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What are different types of control systems?
actually i can't understand what is 3dB ? and it's really not clear to me.please any one let it me be cleared.
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
WHAT IS MEANT BY TV TERMINAL IN 500MVA TRANSFORMER?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
What is the suitable transmission voltage?
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
How can we findout the maximum efficiancy of Transformer? At which load?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is an ideal transformer?
