Interested to Buy Any Domain ? << Click Here >> for more details...
I am working as maintenance engg. in electrical but i want
to do carrier in electrical drawing.Tell me about that.
- 2 Answers
- 4413 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhushan bhamare
as a engg.you working for trubleshutting for ladder,any
mistake in control pannel to proper way,so whenver you have
relax time you read the control pannel drawing,ladder for
PLC,and you have make the carrier in electrical drawing so
you work as a maintance engg because its benifited for you
and get more knoeledge.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calculat the ratio of HT\LT in energy meter
What is difference between start imitation and start interlock for 3 phase motor protection ?
single phase power supply give to separate one steel coup with water, what reaction create
What is the difference between indoor and outdoor transformer
is ac supply can store
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
What are the conditions for sustained oscillator or what is backhouse criterion?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What types of high speed CMOS circuits have you designed?
What is mean by Sensitive Earth fault & what are the effects
What is the criteria that generally follow by distribution licenses to fix contact demand of their industrial customers?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
