Answer Posted / hansraj
electrical term is deal with high power , high frequency,
like transformer, motors etc where as electronics term is
used for less power, less voltage like use diode,
transistors
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
why power not passes in plastic and rubber material
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What technology is used in latest generators?
What is meaning of out of phase (making & breaking) capacity And how to calculate
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
What is steady state response?
How halogen & merquery lamp works.
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
which type of stability limit is higher,steady state or transient? why?
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
bus bar design conditions and sizing pls tell me quickly
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
How i can decide that HVDC line is best for transmission.
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
