what is used for passive intercae comand
mine answer-to prevent to take update from outside
- 2 Answers
- 3415 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinayybx
passivce-interface in rip
in rip the passive-interface will receive the updates but it
will not send any updates to other devices in the network
from that port where the passive-interface is applied
passivce-interface in eigrp
in eigrp the passive-interface wont allow and receive the
hello packets and updates from that port where the
passive-interface is applied
hope this one is right
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In stead of 0.0.0.0 wild card mask what you can write after ip?
Why twist in twisted pairs?
Mention what is the matric of eigrp protocol?
Which command we use for ping in ipv6?
Define the multicast routing?
Can you define LAC
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Briefly explain the conversion steps in data encapsulation.
Can you explain PPP link process step by step?
What is the meaning of synchronization?
What are the different types of passwords used in securing a CISCO router?
What is difference between rip and ripv2?
What are the possible ways of data exchange in ccna?
Which protocol can do load balancing on unequal cost also?
What is loop back ip in ipv6?
