Answer Posted / mithilesh kumar
hi..
1)condensate pots used 1st for the safety point view of
transmitter bcoz maxm range of temp transsmitter is 70degc.
ie. safety point of view...
2)if second pot is in the line then value
(readicator/indication) of TX fluctuating due to variation
in steam density/pressure...ie for accurate reading of
transmitter...
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Full form of KKS when use DCS.
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
Explain the burnout feature.
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
what is the reset offset and control system in instrumentation
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.
What is instrumentation technologists and mechanics?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What is the use of temprature compensation?
What is solenoid valve? Where it is used?
please send data bank of quetions answers on analytical instrumentation.
What is the difference bitween control net scaner and device net scaner
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
