Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hiral prajapati
bas bar is metalic material part it connect supply of
source carry a high rating power transmission.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
What is Surge Capacitor? Why it is require in Generator Circuit Breaker,inspite of surge arrester?
what is the voltage between earth to neutral in lift.
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to calculate vfd o/p voltage by frequency
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
What is accuracy of a measurement?
What is “pu” in electrical engineering?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
plz tel me syllabus and exam date 4 jr executive engg (electrical)
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
why we use circuit breakers for switching instead of normal switching device?
