Interested to Buy Any Domain ? << Click Here >> for more details...
What are the possible causes if load is not same on all the
three phases
- 4 Answers
- 6420 Views
- I also Faced
- E-Mail Answers
Answer Posted / umesh kumar
According to my opinion following are the points due to
laad is not equal in three phase
1)Reactance is not same in each phase due to this voltage
drop is different in different phase so load unbalanced
this is the vital reason
2)Rating of connected equipment is different.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the difference between acs 550 & acs 850
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
what is a pilot wiring and whys that called a pilot wiers
what the function breaker failure scheme, how is it operated
plz explain the auot-reclosing circuit in electrical engineeing
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
what is rocking arrangement in arc heating
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Why need 3phase machine double earthing?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF Govt Polytechnic in deee 2nd year papers
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
