Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hardik goswami
it is the difference of time between actual time of
injection and ideal time of injection.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
ongc recruitment sample paper for asst.technician technical
"When you will install a new piston ring, what will be the position of it?"
What is blower? Partlist of blower.
How to check temperature controller?
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
Do you work for many hours each day?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
What are the causes of I.O. high temperature in a diesel engine?
What is the principle of mechanical refrigeration ?
What is iiucr in relation to petrol engine ?
Which country has the worlds most powerful tank?
can any one send me all the interview questions and test questions on strength of materials . to devarajk23@yahoo.com
I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons
why eta(η) became the symbol of Newton law of viscocity
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
