Interested to Buy Any Domain ? << Click Here >> for more details...
What are the effects to a distribution transformer rated
10Kv with ratio 10Kv/0.433Kv, 3phase 50hz for example but
fed with power supply of 11Kv?
- 2 Answers
- 4267 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
secondary voltage will be 10 % more.This tr is for use at
tail end of a long 11 KV line.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Can we use shunt trip coil instead of trip coil with protection relay for protection?
How many double suspension hardware fittings are required on a double circuit transmission tower?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
what are the parameters plays a major role in Potential transformer Burden calculation??
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
how to select proper cable for ct wiring so that drop within the limit.
diameter of cable and core is doubled then the value of capacitance is
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
Why we are use dol starter up to 10 hp
