When batteries are connected in series the voltage increases
but the current remains unchanged, how can this be?
When you consider ohm's law. i.e.
If voltage increases, current increases, providing
resistance remains the same.
Answer Posted / shahidffc2
what is SIM.?
cause of single phase on SIM ?
how we can check phusical condition of SIM by megger?
SIM behaviour at synchronous speed, ?
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
How can maintain our H.T. motors used in cement plant. please send me procedure.
What is the relationship between voltage,current & frequency?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
What is the height of DA, DAL, DB, DC & DDE tower?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
What is marx circuit?
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
What is the difference between resistance grounding system and resistance earthing system?
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
why 1.7Uo for HV cable Hi pot test?IE standard why?
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.