Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO CHECK THERMOCOUPLE AND RTD & WHAT IS THE DIFFERENCE
BETWEEN THERMOCOUPLE AND RTD
- 14 Answers
- 99775 Views
- I also Faced
- E-Mail Answers
Answer Posted / abdulbasit137@hotmail.com
t/c base of seeback & rtd base of wheatstone bridge kcl.rtd
linear & t/c some distane linear another non linear. t/c
extention cable same use & rtd any other wire use to have.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Speedtronic system .
2. What is ultrasonic flowmeter?
what is interlock system and why we use of this?
Why not come out analog output in ABB EL3020 when display show correct value
how to calibrate 0- 150 psi presure gauge by dead weght tester
detail of mass flow meter pricipal
what is a half wave, full wave, and bridge rectifer.
How will you calibrate PID controller? explain with example.
How d.p. Transmitter can be applied to open tank?
In turbine what does term CDP, NI, NH, HSSOC means.
Which type of pressure can be measured by primary elements?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
how to work static pressure sensore how to work dpt
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
