Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / s.ferna
The ability of synchronous machines of a power system to
remain in synchronism.
Stability phenomena
*Existence of equilibrium between Tm and Te under steady
state condition.
*Upset of the equilibrium, if the system is perturbed.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
Mention the disadvantages of low power factor?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
what is two point starter?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
What happen in ups if phase reverse?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
can anybody sent me power grid questions. what subject should i prefer for preparation?
What is voltage divider rule?
What is the use of Surge Capacitor in LAVT?
