Answer Posted / kaushal
HRC (high rupturing capacity)fuses can be used upto a
current of 300000 ampere at 600 v.
| Is This Answer Correct ? | 9 Yes | 13 No |
Post New Answer View All Answers
Why power factor should not be in leading (capacitive) mode of any load.
explain remenance . differentiate high remenance type ct & low remenance type ct
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
Which device is used for the source of emission of electrons in a crt?
Air refrigeration cycle works on the
Draw the circuit of clapp oscillator?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
What is super thermal power plant? and how it will differ from normal thermal power plant
define digital electronic
what is a power factor?
The loads are connected with phase and ground then why current flow as the loads ?
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
What is the approximate value of stacking factor?
what is stper motor
