Interested to Buy Any Domain ? << Click Here >> for more details...
What is vector group? What is meant by DYN11?Why is it needed?
- 13 Answers
- 86663 Views
- Areva, Bhel, BRG, Escorts, Fortis, I also Faced
- E-Mail Answers
Answer Posted / avnish
above answers are correct but as u asked shraddha that will
hv lead or lv so i clear that capital D is for secondary and
small forthe primary and again 11 ....means that hv have the
30 degree leading phase diffrence..
| Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
how to build a network which step down 415v to 1v rms
Name two low frequency oscillators?
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
How Diesel Generator start ?
Load transfer in 11kv double busbar switchgear - operation.
how open delta PT works & what is its construction?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
What is installed in PAC that is control the humidity
can any tell me why slope 40% and 80% is calculated in differential protection?
