Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using R,Y,B colours for 3 Phase ?
- 4 Answers
- 10456 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / bhupesh
beacause we can see clearlly separate due to there weve
length is very higher in all colours.so we can eisaly
indentfied all three phases.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the comparison of PILC and XLPE cable
can anybody sent me power grid questions. what subject should i prefer for preparation?
how can we calculate the ratio of caustic soda and water in lrs.
what is servo motor and how to work it.
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
How to design harmonic filter at the project stage without nowing the harmonics levels
how you configure motorvision relay (L&T make)from DCS
one electromagnet is called
how to design coil turns ?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
What is negative sequence over voltage element?
How line capacitance & line inductance varies with increase in height tower.
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
Pleae send me last 5 years of Question book about RRB chennai.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
