Answer Posted / dilanka
motor drowse starting current which will be around 2-3 times
the rated current. so cable size going to be increase.How
ever it is suitable to select 125% or 130% current rate for
cable because the cable can withstand without any damage for
few second. you must check the cable manufacturing data to
find this specific time and it should be more than the
starting time period of the motor.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In CTs tan delta point should be earthed , what is the reason behind it?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
What is an Air COmpressor
What is the method of estamating of cable, CB,MCB ?
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
Write the current equation in series RLC circuits.
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
why 1.7Uo for HV cable Hi pot test?IE standard why?
what will happen when the dc supply is given to the capacitor?
What should be the height of basement according to NBCC code?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
What is difference between isolator and circuit breaker?