Answer Posted / sunil ahlawat
Droop is the
permanent
variation in
running rpm of an
generator when
moving from no
load to 100
percent load. It
is calculated in
percentage by
takin no loading
rpm as refrence
Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what are the analog quality input for protection function?what are minimum reqiments?
with help of neat sketch explain principle of TIG welding process
what is the necessity of under ground cables ??
why single CT used in DOL starter power circuit?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
how to calculate micom relay earth falt time and current sertting
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
what is cathodic protaction?
Single line diagram for dbb (double bus bar)system.
given data are load current & power factor cable core size? plz any one update the calculation formula
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.