What are types of losses in the Transmisson Lines ?
- 4 Answers
- 5338 Views
- GE, I also Faced
- E-Mail Answers
Answer Posted / monish
TWO TYPES OF LOSSES:
1. TECHNICAL LOSSES.
2. COMMERCIAL LOSSES.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
which type of questions asking for solar companies?
Define coil span?
Why the cores of large transformers build up of circular cross section?
Why negative feedback is preferred in the control system?
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
how to calculate the settings for shaft ct protn in hydro generators
why industry prefer ht motor instead of lt motor.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
what is through fault?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
