Interested to Buy Any Domain ? << Click Here >> for more details...
How a oxygen sensor & analyzer work at boiler or furnace,
whats the principle & science is beyond this,How O2 sensor
sence & convert signal & move toward analyzer & analyzer
show reading in percent?
- 2 Answers
- 8946 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.surya mutyalaro
apart frm electro-galvanic fuel cell, o2 mesrment is also by
zirconia and paramagnetic prnciple,and thus produces mV.
in a analyser ,there b a programming ,which produces the %
accrding to voltage generated due to ionisation
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
is motorized valve closed when power shutoff?
How to Calibrate Level Switch in field
Describe how to use megger to measure the earth resistance and insulation resistance
Describe the function of Accumulator into the Pump
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
What are the interlocks we have to check during the start up of LP/HP compressor?
What is 3 selection available when configure the burnout protection for controller
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
Explain the working principle of lvdt?
use of split range ? where it is used ? in which control loop it is used ?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
