Answer Posted / amit kumar pandey
A Person who have knowledge of application called Engineer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
Why control of DC motor is simpler?
why are distributed windings generally used in alternators?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Name of the relay of low lub oil presuure in DG sets
Name two types of electrical analogous for mechanical system.
why u r living from presentaly working.
What Normal(Tangent) towers and Tension(Cut-point) Towers?
how many joint can done in HT line and what is life of the joint
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
When is lag lead compensator is required?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
