Interested to Buy Any Domain ? << Click Here >> for more details...
Any website for objective type questions of electrical
engineering ?
- 4 Answers
- 13117 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiran
VISIT: http://electricalquestionsguide.blogspot.com
This blog will be useful for preparing for PSU exams like
NTPC, BHEL, SAIL, BSNL etc and other competitive exam
interviews.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
How many capacitors using in LT panel as per Govt rules?
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
what is the difference between vector scale and vector diagram?
What is effect of over voltage and under voltage on ACB
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
How to calculate the size of earth cable to earth the neutral of UPS ?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
What does Bode plot tell you?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
