Interested to Buy Any Domain ? << Click Here >> for more details...
Do these factors (settling time, peak time, steady state
error, overshoot, rise time, MPOS (Maximum percent over
shoot)) are the part of first order, second order, higher
order, linear, non-linear, open-loop, closed-loop,
homogeneous & non-homogeneous systems ?
- 1 Answers
- 5477 Views
- Limton, I also Faced
- E-Mail Answers
Answer Posted / saasa
yes,igot ur point..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the difference between normal application Transformer and Solar application Transformer?
What is a compensator?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
Write down the design procedure of commutaj.
What is meant by rotor?
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
What is the comparison of PILC and XLPE cable
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
Phase control and integral control are used for?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
How we calculate DC inducation moter Amp? Sir pls give me formula......
What do you mean by power transformer?
Define relative stability.
Alternator rotor earth fault relay circuit
