Interested to Buy Any Domain ? << Click Here >> for more details...
What are the earth resistance Standards of 66kv sub
stations according to indian norms.
- 2 Answers
- 4398 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
2 ohms and below.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what transformer we used normally and upto which kva?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
What is effect of over voltage and under voltage on ACB
why we r not earthed Control cable of C.T. terminals
what parameters are should nessary for control technic dc drive(in rolling mills)?
In parallel operation time both NGR’s close or not close if both close what will happen
what is p.s impedance measurement test in earthing transformer?
which VFD is better ( LT or HT)
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Why can't we parallel the secondary circuits of two voltage transformers?
How to calculate earth wire load by formula
Give two basic speed control scheme of dc shunt motor?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
What is the power factor of an alternator at no load?
