Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohammed abbas
AS it is mentioned in the above answer data sheet is the
best because data sheet range is master.Base on the range
of the data sheet,it will be set in the dp transmitter.
you can check the range of dp tx by using the HART (275) OR
field bus (375)commnuicator with reference as a data
sheet.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the basic difference between Modbus and CAN Open Protocols
Why ac supply load cell is used? Can we use the dc supply load cell?
selection criteria of control valve? and selection criteria of actuator explain in brief?
How d.p. Transmitter can be applied to close tank?
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
is motorized valve closed when power shutoff?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
What is the use of temprature compensation?
Make Heater Process Logic.
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
Isometric drawings are generated during _________________ phase of a project
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is the difference between -24 : +24 & 0:24 and where it use?
