Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k. murali
seem less tube are produced in cold extrusion process
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Enumerate some trouble of fuel injection valve
Can you use motor oil in a hydraulic system?
What are the rules that must be kept in mind while designing castings?
What do you understand by timed cylinder lubrication ?
Who discovered non-newtonian fluids?
An elastomer is a polymer when its percentage elongation rate is ?
why study in Michigan tech univ
how to calculate the size and weight of induced draft axial fan impeller
How do you detect earth by lam p?
What is the percentage of chromium in 18 : 4 : 1 iiss ?
How to find the amount of natural gas required to produce 1kwhr of energy?
Dear sir/madam, plz sand me techanical test question (mechanical)
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
What is the specific heat of water?
