Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohammed abbas
compensation is a process of cancelling unwanted value
added to the actual value or reading of procees parameter
which will effect the quality and quantity of the product
which leads to accident or effect the cost.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is 1:1 redundancy ?
Who to difference between analog in & analog out in dcs?
Explain Gas Turbine startup and shutdown sequences
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
can any send me a forbes marshall dtron 316 manual
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
What are different types of orifice plates?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is the difference between profibus and controlnet networking.
Which topics are covered in Process Control?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
Describe the function of Accumulator into the Pump
