Answer Posted / raju.j
This is about amount of rejection of Parts Per Million(PPM)
products...
In 6sigma industry 3.4parts only rejected i.e defected per
million product....99.9997% products are good.
In 3 sigma industry 2700parts are rejected i.e defect per
million product....
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is the difference between gear motor and a stepper motor? Like i want to use gear motor for its excessive torque to move my robot. Can i use stepper motor instead?
WHAT IS EASY & PERFECT METHOD TO JOIN CONVEYOR BELTSEXPLAIN IN DETAIL
I'm a first year student of B.E Mechanical Engineering... How should i prepare myself for getting selected in campus interviews from now itself...? What books should i refer....?
please send me latest hindustan petrolium papers
Relatesd Applied Mechanics
why it is difficult to make heavy cuts if a form turning tool is complex in shape?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
what is cathodic protection? where it is used and when? and why?
Explain the cycle of refrigeration system.
what is tooth profile
Differentiate between the uniform flow and non-uniform flow?
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
what type of questions will be there in the written paper of tata motors ?
what shows avribiations related to bearing blocks
