Any can guide for QA/QC Inspector in oil & gas region, the
procedures, formats standards, design criteria, i search in
all enginees but i can't found wat i need?????????
- 4 Answers
- 19775 Views
- Aramco, Asian Paints, I also Faced
- E-Mail Answers
Answer Posted / guest
try to find saudi aramco engineer standard .
| Is This Answer Correct ? | 16 Yes | 4 No |
Post New Answer View All Answers
draw the block diagram of a level transmitter ?
How to calculate P,I&D value in PID controller ?
if in a level tx height is given, how u calculate the ranges of the tx?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
what is the procedure of O2 sensor(ABB) calibration?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Explain operation of Haskel pump.
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
what is performance test.need defination
key exchanges in wpa,wpa2,tls
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
What is 3 element control system
Questions on flow meters,few questions on HART protocol,
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
