Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sreekumar
synchronising is the process of connecting generator in
parallel with terminal voltage,phase and frequency must be
same.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
How to test the Secure Elite 440 Multi function meter working condition.
What is A check, B check, C Check & D check for a diesel Generat
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Difference between ac parallel circuit and ac series circuit?
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
condition Autotrip facia come on control panel of electrical transmission line?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
Motor,transformers,capacitor tubelight etc....
Name two types of electrical analogous for mechanical system.
what is meant by 3rd hormonics ?
why ht cable end termination don't have a gland?
