Answer Posted / karthikeyan
KVAR is the unit of reactive power (Kilo Volt Ampere
reactive). It is the amount of reactive power in the system.
Droop is defined as the rate of fall of the speed of a
alternator, which are connected in parallel,with increase in
load.
Stability is defined as the ability of a generator to remain
in synchronization even when there is a disturbance in the
system(Faults).
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
10 Mtr Hight of Lighting Arrestar how much area coverd??
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
If you have an earth with pilecap then your resistance is really low. why and how?
send me any model test paper of clerical post of state bank of india.......
what is the safety points of vaccum circuit breaker.
which of the following elements is not present in stainless steel
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
what is the total power generation in india?
how will we calculate the copper wire load..
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
what is stper motor
3phase cable calculation formula by motor load
PAC and simple Ac different