Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tarique shamim
the flow of free electrons is called current.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How is operate breaker failure scheme in substation
What is DTR erection?
How to checked frequency drive output voltages?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
what's producer of XLPE cable laying in undergroung
Difference between transition and diffusion capacitance
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
As i want some model question paper in basic computer science and history please send me immediately sir
1.how many types of relays? 2.difference between ATS& STS?
Why we find the sensitivity for the CT's to check?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
