Interested to Buy Any Domain ? << Click Here >> for more details...
why we step up voltage for reducing the loss, even if
voltage and current are proportional anr resistance remains
same
- 12 Answers
- 28787 Views
- Sarhad University, I also Faced
- E-Mail Answers
Answer Posted / pranav pathak
For transmission we are step up the voltage, Not only
reducing the losses but there are many reason to step
up the voltage
1) Transmission line conductor is calculated behalf of
current capacity.To transmit high current we have to
provide big diameter cable/line, and big diameter line
cable weight is more.Which is costly, Tower cost
increase.
2) current less means conductor diameter size will
less.Conductor cost will be less.
3) Obiviously the copper loss is dependent upon current,
Current less, It will help to reduce the copper loss.
So main reason to step up voltage is, to reduce cost of
material.To make the rigid the system.Easy for maintenance.
Exm.:- In generation station first we generate 11 kv, and
after generation we provide stape up transformer.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
what is feeder bay?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
You are of electrical field and you are going for software? Why
Electrical Engineering
Which is the oldest hydropower plant in india?
What is the purpose of stand by earth fault protection for transformer ?
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
can you plz send l&t aptitude questions if available its urgent plz plz plz
how to build a network which step down 415v to 1v rms
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
State thevenintheorem?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
How we can calculate the life of Lead acid battery
