Interested to Buy Any Domain ? << Click Here >> for more details...
why condensate pump can be used instead of feed pump?
- 1 Answers
- 3543 Views
- I also Faced
- E-Mail Answers
Answer Posted / balakrishnan
Condensate pumps as used in hydronic systems are usually electrically powered centrifugal pumps. As used in homes and individual heat exchangers
Feed pumps used to feed fuel to the engine(for fuel)
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
HOW TO CALCULATE THE FILTER ELEMENT AREA FOR VISCOUS FLUIDS IN CASE OF PLAETED METTALIC FILTERS
Steam turbine (function an parts)
What are the advantages and disadvantages of gear drives over belt drives?
what is the advantages and dis advantages of critical speed of turbine.
What causes cylinder liner-wear down?
How to calculate the no of straps required to hold a bar bundle which varies in different length? Ex say 6M bar ,weights 1.3 ton with 250 bars in the bundle.
What are the causes of boiler backfire and steps in how to prevent it from happening?
Why would you use pneumatics?
What causes turbocharger surging?
Why are open the ejector air vents.
bag filter ,monitooringof exection/ co -ordination of site activities format
What type of boiler does not need a steam drum ?
What are the causes of low compression in the main engine?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Please brief me about Ball-screw.
